Dear model fliers! Vladimir's Model is doing his best for you to get the greatest pleasure on each step of communication with our models. We wish you many happy hours of flying with our machines.
Technical data: Simply the best
150 180
Wing span 1480 mm 1800 mm
Wing area 22,5 dm2 29,64 dm2
Length 875 mm
Weight
150 180 150/5 180/5
115 g 130 g 122 g 137 g
Wing airfoil S-4083
Tail airfoil NACA63A007
Controlling elements Elevator, ruder, flaps (ailerons)

Center of gravity () is 95-102 mm from the
leading edge.


Convert just about anything to anything else.

Simply the best 150
Simply the best 180
This is a beautifully hand-made HiTech competition HLG that is constructed using competition free-flight techniques.

This is a fully built glider that needs only radio installation. Minimum weight of the fuselage and V-tail, the long tail moment and large tail surfaces enhance low speed handling. Due to its geometrical parameters "Simply the Best" is tracking well with no Dutch roll tendencies and at the same time handles with agility.

The wing is a built-up Kevlar sheeted D-box design that utilizes carbon fiber faced balsa ribs and a carbon fiber strip trailing edge. The spars are made of HiTech carbon plates with balsa vertical direction and whipped with kevlar thread. The carbon longerons of special quality provide super strength.The carbon landing edge has minimum weight and maximum srength. All plastic elements of the wing are made with high pressure and temperature of 150C. The rear section of the wing is covered with Oracover Lite. The wing has three sections connected with joiners. The wings are made extremely accurate, the construction is very strong, rigid and light and the construction will be not damaged by the environmental influence. The construction of the model allows to fly the model for a long time and it will be still as a new one.

The hand-built V-tail is made from contest balsa and laminated with carbon fiber strips, then covered with Oracover Light. The elevators are covered and hinged.The stabiliser has an original joiner and can be easily removed or attached to the fuselage. It is cool for transporation. The model is completed with original carbon horns.

The fuselage is all Kevlar with carbon fiber reinforcement and gel-coated different colors. The canopy is hand fitted and has a unique built in latch system that is both very light and very easy to use. The place for the finger hole necessary for the cool launch is prepared on the fuselage (it is reinforced with carbon). The fuselage has minimum weight - 42g. with canopy.

For order or questions connect to info@airplane-model.com